Installation method of floor lamp

In addition to the chandeliers and wall lamps that are bulky and bulky, lamps such as table lamps and floor lamps can be installed by yourself. Although the installation method of each lamp is slightly different depending on the product design, it is often the same. We only need to pay attention to the following points when installing floor lamps:
1. Read the installation drawings carefully before installation, and prepare common tools, such as flat cross screwdrivers, hammers, etc. After unpacking the parts, it is best not to confuse them. If there are many similar parts, the drawing will draw a comparison diagram of actual size, and cross out the unused parts, which is very easy to distinguish various parts.
2. If the plate is found to be damaged during the inspection, you can contact the merchant for replacement parts. Where screws, eccentric parts, and wooden shafts are to be installed, guide holes will be made, so there is no need to worry about the positioning of parts. It should be noted that it should not happen that the wrong parts are installed and then repeatedly screwed together, otherwise the board will be easily damaged, and the installation will often cause instability and tilt.
3. Generally, the floor lamp should have a cast iron chassis, which is slightly smaller than the surface base. The order of spare parts from bottom to top should be: chassis fastening nut, cast iron chassis, base, lamp pole, lamp cap, lampshade, plastic fasteners, Light bulb.